You will have 1 Cabinet I/O and 1 or 2 Door I/O boards in a upright machine.Ĭheck the connections to each display in the machine, VFD and 7 segment displayĬheck the 3 connections to the Bill Acceptor in an upright machine they are behind the Bill acceptor, near a light that gets very hot quickly so be carefulĬheck each connection to the motherboard just disconnect and reconnect it, do one at a time so you do not lose track of where a connection goes. Make sure the 2 or 3 I/O cards are fully seated any harnesses connected to the handle end of them is fully connected. Gently push in the mpu with both hands because sometimes, it may not be fully seated When this happens start with the device that you are getting the error about and work back to the motherboard.įirst try clearing the error by lifting and lowering the main door latch a few times.Īlways do the following with the machine off just in case. The S2000 will tilt if anything gets disconnected or loose
